Relocating an electrical panel can be complicated. A detailed plan must be created to ensure that electrical equipment will work properly. Some utilities may even charge an additional fee if the new location is too far from your old one. If you’re planning on remodeling or adding a new room, it is a good idea to contact an electrical contractor for assistance. The process can be tedious and time-consuming, so it is important to take the time to plan carefully and thoroughly.
Things To Consider Before Relocating A Electrical Panel
- Before you begin, you’ll need to remove the existing breaker box and extend the wires to the new location
- If you’re relocating your electrical panel, you’ll need to check the building codes in the area.
- If you need to move the panel, it’s important to contact a licensed electrician.
- Additionally, you’ll need to ensure that the location is safe for your family and your employees. If you plan to relocate your electrical panel, it’s essential to follow safety guidelines to prevent any accidents.
Steps In Relocating Electric Panel
- The first step in relocating an electrical panel is to unplug it.
- Make sure there is no power to the circuit. Be sure to unplug everything before you begin.
- If you have to remove the breaker box, you’ll want to cut the overhead cable.
- You can also keep the existing outlet on the wall.
- Then, remove the receptacle from the old box and stretch the wires. If it has a knockout, install a cable connector into the knockout.
- The next step is to remove the old panel box and disconnect it from the main service line.
- You’ll need to use the same screws or replace the existing screws.
- Then, reconnect the wires in the same order as they came out of the old panel box. You may also need to disconnect the primary service line to avoid electrical hazards.
- Remember to turn off the power to the new panel box.
- You should avoid tripping over live wires and breakers.
- Once you’ve relocated the panel box, it’s time to reconnect it to the new location.
- After the panel is disconnected, you can reattach it to the new location by using the same screws.
- Be careful not to touch any bare wires – they could get energized and cause a serious accident.
Do We Need Electrician When Relocating Panel Box?
If you need to relocate an electrical panel box, you should contact an electrician. The electrician will need to cut and splice wires to move the panel box to the new location. During this process, you’ll need to reinstall the panel box with the same screws. When you have moved your panel box, you’ll need to replace the screws. If your electrical system is located at a different location, the wiring can be run to a new location, and the electrician will need to do this work.